EFFECT OF REFUSE-DERIVED FUEL FEEDING RATIO ON PERFORMANCE AND STABILITY OF COMBUSTION TEMPERATURE CONTROL

Authors

  • Nontakorn Phakphoom Suranaree University of Technology
  • Pansa Liplap Suranaree University of Technology
  • Janewit Wannapeera Suranaree University of Technology
  • Thipsuphin Hinsui Suranaree University of Technology
  • Weerachai Arjharn National Science and Technology Development Agency in Science Park
  • Thitikorn kijjanasiri Suranaree University of Technology
  • Kanchanaporn Sribunrueang Suranaree University of Technology

DOI:

https://doi.org/10.55766/sujst-2023-05-e0936

Keywords:

Direct combustion, Refuse-Derived Fuel, Biomass, Pottery kiln

Abstract

In this study, the effect of Refuse-Derived Fuel type 3 (RDF-3) feeding ratio on a performance and a stability of combustion temperature control was exmined. A new direct-combustion furnace was designed and constructed for co-combustion of RDF-3 and woodchip (WC) feedstock. In this work, four main ratios on wet basis of WC and RDF-3; 100 : 0, 90 : 10, 80 : 20, and 70 : 30 wt.% were tested at the combustion temperature of 970°C. The results showed that the complete combustion was achieved from all of feeding ratios. From an actual fuel feed rate, an increase in RDF mixing ratio could reduce the using of pure woodchip by 5.3 wt.%, 14.3 wt.% and 34.0 wt.% when mixing the RDF at 10 wt.%, 20 wt.% and 30 wt.%, respectively. At increasing of RDF mixing ratio, non-smoothy burning was also found to increase, however, a more rapid ignition behavior of was achieved

References

Abu‑Elyazeed, O.S.M., Nofal, M., Ibrahim, K., and Yang, J. (2021). Co‑combustion of RDF and biomass mixture with bituminous coal: a case study of clinker production plant in Egypt. WDSE., 3:257-266.

Aich, S., Behera, D., Nandi, B.K., and Bhattacharya, S. (2020). Relationship between proximate analysis parameters and combustion behaviour of high ash Indian coal. Int J Coal Sci Technol., 7:766-777.

Akdağ, A.S., Atımtay, A., and Sanin, F.D. (2016). Comparison of fuel value and combustion characteristics of two different RDF samples. Waste Manag., 47(Pt B):217‐224.

Chen, X., Xie, J., Me, S., He, F., and Yang, H. (2019). RDF pyrolysis by TG-FTIR and Py-GC/MS and combustion

in a double furnaces reactor., J. Therm. Anal. Calorim, 136:893-902.

Chiemchaisri, C., Charnnok, B., and Visvanathan, C. (2010). Recovery of plastic wastes from dumpsite as refuse-derived fuel and its utilization in small gasification system. Bioresource Technology, 101:1,522-1,527.

García, R., Gonzalez-Vazquez, M.P., Rubiera, F., Pevida, C., and Gil, M.V. (2021). Co-pelletization of pine sawdust and refused derived fuel (RDF) to high-quality waste-derived pellets. J. Clean. Prod., 328:129635.

Hemidat, S., Saidan, M., Al-Zu’bi, S., Irshidat, M., Nassour, A., Nelles, M. (2019). Potential Utilization of RDF as an Alternative Fuel to be Used in Cement Industry in Jordan. Sustainability., 11(20):5,819.

Ikeda, M., Makino, H., Morinaga, H., Higashiyama, K., and Kozai, Y. (2003). Emission characteristics of NOx

and unburned carbon in fly ash during combustion of blends of bituminous/sub-bituminous coals. Fuel., 82:1,851-1,857.

Kara, M. (2012). Environmental and economic advantages associated with the use of RDF in cement kilns. RCR., 68:21-28.

Karpan, B., Raman, A.A.A., and Aroua. M.K.T. (2021). Waste-to-energy: Coal-like refuse derived fuel from hazardous waste and biomass mixture. PSEP, 149:655-664.

Li, J., Paul, M.C., Younger, P.L., Watson, I., Hossain, M., and Welch, S. (2015). Characterization of biomass combustion at high temperatures based on an upgraded single particle model. Appl. Energy., 156:749-755.

Liplap, P., Arjharn, W., Watakit, K., Koonsrisuk, A., and Hinsui, T. (2022). Beneficial Use of RDF (Refuse Derived Fuel) from Municipal Solid Waste in SMEs (Small-Medium Enterprises) or Small Industries. National Research Council of Thailand (NRCT).

Liu, X., Chen, M.Q., and Wei, Y. (2015). Kinetics based on two- stage scheme for co-combustion of herbaceous biomass and bituminous coal. Fuel., 143:577-585.

MNRE, Ministry of Natural Resources and Environment. (2006). Notification: Determination of Emission

Control Standards Air pollution. Available from: https://www.pcd.go.th/laws/4010. Accessed date: May 26, 2022.

Phakphoom, N., Liplab, P., Hinsui, T., and Arjharn, W. (2022). Effects of combined RDF and biomass on performance and emissions of a ceramic kiln. TSAEJ., 28(2):33-41.

Pollution Control Department [PCD]. (2018). announcement of the Pollution Control Department: Guidelines for effective management of solid waste with incinerator. Available from: https://shorturl.asia/jhcSd. Accessed date: September 26, 2018.

Pollution Control Department [PCD]. (2021). The state of solid waste in the country. Available from: https://thaimsw. pcd.go.th/report1.php?year=2564. Accessed date: May 19, 2022.

Downloads

Published

2023-12-14

How to Cite

Phakphoom, N., Liplap, P., Wannapeera, J., Hinsui, T., Arjharn, W., kijjanasiri, T., & Sribunrueang, K. (2023). EFFECT OF REFUSE-DERIVED FUEL FEEDING RATIO ON PERFORMANCE AND STABILITY OF COMBUSTION TEMPERATURE CONTROL. Suranaree Journal of Science and Technology, 30(5), 010252(1–7). https://doi.org/10.55766/sujst-2023-05-e0936