CRITICAL DRYING POINT OF DAN KWIAN POTTERY

Authors

  • Sutham Srilomsak School of Ceramic Engineering, Institute of Engineering, Suranaree University of Technology
  • Weera Luangsiritunya School of Ceramic Engineering, Institute of Engineering, Suranaree University of Technology
  • Ekkachai Dungphontong School of Ceramic Engineering, Institute of Engineering, Suranaree University of Technology
  • Surachai Chaisrihad School of Ceramic Engineering, Institute of Engineering, Suranaree University of Technology
  • Puthapong Sukphoem School of Ceramic Engineering, Institute of Engineering, Suranaree University of Technology
  • Werayut Boonyarut School of Ceramic Engineering, Institute of Engineering, Suranaree University of Technology
  • Nitipon Pradadking School of Ceramic Engineering, Institute of Engineering, Suranaree University of Technology

DOI:

https://doi.org/10.55766/sujst15927

Keywords:

Critical moisture content, Dan Kwian pottery, drying

Abstract

Dan Kwian pottery is a beautiful and unique pottery which brings both reputation and large amount of income to Nakhon Ratchasima province. However, most of the factories in Dan Kwian district are still using basic production techniques which have been inherited for many decades especially drying technique. At present most factories in Dan Kwian are drying their greenwares in grass-walled huts.This causes not only longer drying time but also the drying period to depend upon the seasons. Critical moisture content of Dan Kwian pottery was studied in this work in order to be used as the data to improve the drying technique of Dan Kwian pottery. It was found that the critical moisture content of Dan Kwian pottery is about 10 - 15%. Therefore we should be able to decrease the drying time of Dan Kwian pottery by increase its drying rate after its moisture content was reduced to below 10%.

References

สุธรรม ศรีหล่มสัก. (2543). เอกสารประกอบการสอนวิชา 526303 Drying of Ceramics. สาขาวิชาวิศวกรรมเซรามิก, มหาวิทยาลัยเทคโนโลยีสุรนารี, นครราชสีมา, หน้า 16-26.

Brosnan, D.A., and Robinson, G.C. (2003). Introduction to Drying of Ceramics With Laboratory Exercises. 1st ed. The American Ceramic Society, Ohio, p. 57-76.

Chimnakom, E. (1999). Inside Dan Kwean Pottery Village. 1st ed. Benja International LTD Part, Bangkok, p. 1-30.

Ford, R.W. (1986). Ceramics Drying. 1st ed. Pergamon Press, Oxford, p. 1-60.

Lawrence, W.G. (1972). The nature of clays. In: Drying Claywares. Kirkendale, G.A. (ed). New York State College of Ceramic at Alfred University, NY, p. 1-42.

Tuttle, M.A., and Funk, J. (1972). Water removal from clay. In: Drying Claywares. Kirkendale, G.A. (ed). New York State College of Ceramic at Alfred University, NY, p. 55-71.

West, R. (1972). Drying clay ware. In: Drying Claywares. Kirkendale, G.A. (ed). New York State College of Ceramic at Alfred University, NY, p. 43-54.

Downloads

Published

2026-08-27

How to Cite

Srilomsak, S., Luangsiritunya, W., Dungphontong, E., Chaisrihad, S., Sukphoem, P., Boonyarut, W., & Pradadking, N. (2026). CRITICAL DRYING POINT OF DAN KWIAN POTTERY. Suranaree Journal of Science and Technology, 13(4), 363–371. https://doi.org/10.55766/sujst15927

Issue

Section

Research Article

Categories